Show your support
@Jessica do you ever have issues with leaking? I dont know what im doing wrong but occasionally they leak out of the bottom x
I've found that usually, when they leak, it's water from the steriliser rather than the water/milk itself. Are you using the lid to push the white bit into the bottom? This makes it fit perfectly. We used to use the mam bottle warmer, and still sometimes use a jug of boiling water to heat the bottle up, we haven't had any issues so far (LG is 6 months), but if you take the lid off when warming, it prevents the suction/vaccum effect, so shouldn't suck any additional water in through the holes (this is what the mam bottles warmer instructions tell you to do).
@Steph not that I’ve noticed but I usually heat my milk up in hot water (I use breast milk) so there’s kind of water on the bottle already. Maybe I’ve missed any leaking 😅
Nah I just heat in the microwave!
If I’m out and pre make a bottle I’ve had to rinse under hot water to warm it up.. I’ve found if I put in a jug of hot water the water seems to get in! Just read from above tho.. I’m sure I’ve had the lids on.. didn’t realise this! It that case I will try again 😅🥰
@Chloe yes i use the lid to squish the white bit down. ill take the lid off when using the warmer, thank you! Xx
I use a thermos and the only time I've had milk leak out the bottom was when the white part needed replacing so I just got a new bottle.
i use momcozy portable warmer , it screws o where the lid goes so the base touches nothing and there’s no water involved xxx
If you take the lid off whilst you’re warming it up it should stop x
I work with a family who used mam bottled for their youngest when she was baby, I used to use a jug with hot water to warm up milk, it wasn't leaking into the bottle but when it was wet it was just from where the bottle had been in the jug of water x
I use bottle warmers with maam bottles and not ever thought of that or seen much issue as long as all parts are correctly pushed in . When I take the bottle out the warmer to use after testing temp of it I use a t-towel and shake the bottle upside down to get the hot water out any little gaps and wipe all over so littlen doesn’t get hurt as he likes to hold and touch the bottle x
I also take off the plastic lid when warming up but not the screw on teat x
I do but I didn’t think about that so following